1. Each plastic has an ideal plasticizing processing temperature range. The barrel processing temperature should be controlled to make it close to this temperature range. The granular plastic enters the feeding barrel from the hopper, and it will first reach the feeding section. Dry friction will in... Read More
In the injection molding production and processing, the phenomenon that the screw of the injection molding machine is stuck and does not rotate often occurs. If the screw protection device of the injection molding machine does not work, the operator should stop the machine immediately. In many cases... Read More
1. The speed should be adjusted properly. Because some plastics are added with reinforcements, such as fiberglass, minerals or other fillers. The friction of these substances on metal materials is often much greater than that of molten plastics. In the injection of these plastics, if the high speed ... Read More
The screw of the injection molding machine works under high temperature, high pressure, high mechanical torque and high friction environment for a long time. The first few factors are required by the process conditions, and the loss caused by friction is inevitable. Generally, the screw has been sub... Read More
Material performance 1. The material performance of the Granulation screw is mainly manifested as excellent electrical insulation (especially high-frequency insulation), white hard and brittle, metal sound when dropped on the ground, light transmittance second only to organic glass, coloring and wat... Read More
